Ringfeder TNZ ZCA/TNZ ZCB Gear Coupling
Product Name: Ringfeder TNZ ZCA/TNZ ZCB Gear Coupling
Product Brand: Ringfeder
Product Code: TNZ ZCA/TNZ ZCB
Product Artikel: Ringfeder TNZ ZCA/TNZ ZCB Gear Coupling
Standard hubs
The RINGFEDER ® TNZ ZCA coupling is a torsionally stiff gear coupling designed to have some backlash and consists of two coupling halves that are connected by fitted bolts. Unlike the TNZ ZCA coupling, the RINGFEDER ® TNZ ZCB comes with a bolt-on O-ring carrier which facilitates installation by changing the mounting sequence. For mounting the coupling, unscrew the cover and place it on the shaft. Mount the hub onto the shaft, slide the sleeve onto the hub and fasten the O-ring carrier to the sleeve. This way of mounting is advantageous when large couplings are involved. Characteristics
General features
Torsionally rigid gear coupling made of high-quality steel
Very compact design results in a high-power density
Compensates for angular, radial and axial shaft offset
Suitable for use in temperatures up to +120 °C if special seals are used
Available with split sleeve (ZCA / ZCB - ZCA model range also available in ZCB design) and single-piece sleeve (ZCH)
The elastic O-Ring can be replaced without having to move the coupled machines
Bores up to 270 mm
Torques up to T Kn = 195,000 Nm / T Kmax = 390,000 Nm
Speeds up to n max = 6,000 rpm
General description
The RINGFEDER ® TNZ coupling is a torsionally rigid twin cardanic gear coupling.
Toothing
The coupling housings have a straight internal toothing whilst the hubs have an external toothing with a chased variable radius. As a result, the hubs can move spatially within the housing and thus compensate angular, radial and axial shaft misalignment of the adjoined shaft ends within specified tolerances. Depending on coupling type and size, the standard toothing permits an angular misalignment of up to 0.5 degrees per toothing-plane and an axial movement of several millimetres. The max. possible radial shaft displacement is dependent on the distance between the two toothing planes. Other toothing geometries can be used for further specific applications.
Materials
High-grade tooth profiles and grease with ultra high-pressure additives guarantee low-restoring forces and a long serviceable life. The material used is forged steel with an apparent yielding point of at least 335 N/mm 2 . Special materials can be used for further specific applications. Sealing is carried out using O-Rings of synthetic rubber. The housings are centred and held together by fit-bolts and self-locking nuts.
Temperature
The use of special seals permits the temperature limit to be raised to 120 °C.
Balance
At peripheral speeds upwards of 30 m/s it is advisable to dynamically balance the coupling.
Special applications
If greater misalignments are anticipated at higher speeds and torques, an examination is necessary, performed with the assistance of a special computing programme. This is independent of the determined size. The value T Kmax may not be exceeded in any state of operation (start-up, electrical short circuit, blocking, etc.).
Tolerances and standards
The bore tolerance is ISO H7, if not differently ordered. The bore diameters listed refer to keyways to DIN 6885-1 with toleranz ISO P9.
