EKF CCA-LAMBADA I/O Companion Board
EKF
Product number: EKF CCA-LAMBADA I/O Companion Board
Artikelnummer: CCA-LAMBADA
Producer: EKF
Confirmed Rating:
☆☆☆☆☆☆
(4.1)
Rating Count: 3147
You can fill in the online quotation form or get in touch with Live Support Team for the EKF brand, EKF CCA-LAMBADA I/O Companion Board product. We will get back to you as soon as possible.
PLEASE MAIL TO: info@allinstock.net
Datasheets for EKF CCA-LAMBADA I/O Companion Board
Description for EKF CCA-LAMBADA I/O Companion Board
Available as a companion board to the CC9- SAMBA CPU card, the CCA-LAMBADA is provided with common legacy I/O ports. Interconnection between the CCA I/O module and the CPU carrier board is achieved by the expansion connector, which incorporates e.g. the LPC (Low Pin Count) and AC'97 (audio) interface. As an option, the CCA-LAMBADA is available with a rugged on-board 2.5-inch hard disk drive (1.8-inch as a mezzanine module). The CCA-LAMBADA can be attached either left or right (bottom or top) to the CPU board, and is provided typically with a 4HP front panel. In addition to its front panel I/O connectors, the CCA-LAMBADA has been designed also for rear I/O and therefore requires a non-bussed singleslot P1/P2 backplane in addition to the CompactPCI bus. However, if front panel I/O is solely needed, the J1/J2 connectors may be omitted as an option.The CCA-LAMBADA communicates to the host CPU by means of the expansion connector, which incorporates the LPC and AC'97 interfaces. The LPC (Low Pin Count) is a multiplexed ISA bus, enabling the super-I/O controller chip to emulate the legacy I/O interfaces. Among these are parallel and serial ports, the PS/2 interfaces, and last not least the classic 1.4/2.8MB floppy disk controller. The AC'97 interface is used for control of an optional audio codec on the CCA-LAMBADA. By connecting the boards together, the hosts ATA/IDE secondary interface is also available on the CCA-LAMBADA. Optionally, the board can be equipped with either a CompactFlash mezzanine module, or a robust 2.5-inch hard disk drive, particularly suited for use in a rugged environment. A mezzanine module will be also available which carries an 1.8-inch drive, as an alternative. The CCA-LAMBADA can be mounted either on the left (bottom) side of the CPU board, or right (top) side. Specify your actual needs when ordering the unit.
Latest Comments for EKF CCA-LAMBADA I/O Companion Board
Other Recommended Products EKF